-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueCreating a Culture of Collaboration
PCB designers could learn quite a bit from NASA and the private companies that develop spacecraft: Every one of these vehicles is a testament to the value of collaboration among disparate stakeholders. Without a collaborative culture, the rocket might never get off the ground.
Breaking High-speed Material Constraints
Do you need specialty materials for your high-speed designs? Maybe not. Improvements in resins mean designers of high-speed boards can sometimes use traditional laminate systems. Learn more in this issue.
Level Up Your Design Skills
This month, our contributors discuss the PCB design classes available at IPC APEX EXPO 2024. As they explain, these courses cover everything from the basics of design through avoiding over-constraining high-speed boards, and so much more!
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Estimated reading time: 1 minute
Beat the Traffic Jam - Effective Routing of Multiple Loads
In a previous Beyond Design, Impedance Matching: Terminations, I discussed various termination strategies and concluded that a series terminator is best for high-speed transmission lines. Different terminating strategies have advantages and disadvantages depending on the application, but, in general, series termination is excellent for point-to-point routes, one load per net. In summary, series termination reduces ringing and ground bounce.
But, what if there are a number of loads--how should these transmission lines be routed? For perfect transfer of energy and to eliminate reflections, the impedance of the source must equal the impedance of the trace(s) to the load.
Bifurcated transmission lines, traces that are split into two or more T-sections, are sometimes used to distribute signals to multiple loads. The impedance of the bifurcated line is not constant along the trace route, as the traces branching from the T-section are virtually in parallel when you consider the equivalent AC circuit. In this case, proper termination has not been provided and an impedance discontinuity can be seen at the branch point. In Figure 1, a 50 ohm signal from the driver is split into two transmission lines of 50 ohms and then into the loads. At branch (A), the two 50 ohm traces in parallel equate to a 25 ohm equivalent trace, and a mismatch in impedance. Figure 2 illustrates the resultant waveform of the unmatched transmission line.
Editor's Note: This column originally appeared in the February 2014 issue of The PCB Design Magazine.
More Columns from Beyond Design
Beyond Design: Dielectric Material Selection GuideBeyond Design: The Art of Presenting PCB Design Courses
Beyond Design: Embedded Capacitance Material
Beyond Design: Return Path Optimization
Beyond Design: Just a Matter of Time
Beyond Design: Design Success with IPC Standards
Beyond Design: Integrating AI Into PCB Design Flow
Beyond Design: Standing Waves in Multilayer PCB Plane Cavities